Humboldt, NE – 443.575 – K0HAM

The Humboldt, NE repeater on 443.575 is mixed-mode using a HamVoIP Allstar node for analog and an MMDVM with DMR mode enabled.

Inventory:

Note: Analog mode has priority over digital modes on this repeater.

FM Setup:

RX Freq: 443.575
TX Freq: 448.575
CTCSS/TSQ: 88.5
- Using TSQ (CTCSS decode) on your radio will mute the digital modulation.

DMR Setup:

Your radio will have to be programmed with your unique DMR ID (obtained from the RadioID.net website)
Each channel will have to be configured with:
1. RX Freq: 443.575
2. TX Freq: 448.575
3. Color Code: 1
4. The time slot and group contact ID of the group you want to use from the list below:

KS-DMR/NE Repeater TGID table

Table showing the available talk group ID's on repeaters connected to the KS-DMR/NE (Nebraska) system.

Group	Timeslot	TGID
System Local (KS-DMR "Chat")	1	2
Repeater Local	1	8
Voice for Linked Group	1	9
Nebraska TRBO	1	3131
Kansas Statewide	2	3120
Subscriber to Subscriber calls (brief)	1	(Private radio ID)

To access any of the available linked groups:

Select the channel programmed with TS1:TG9.
Go into your contact list, select the talkgroup (from the list below) you wish to link to and key PTT for two seconds with the desired linked group selected. When you unkey the link will be activated.
When your radio display reverts back to S1:G9 you may begin talking.
- Note: The linked group ID’s are to be used for in-band signalling to trigger link activation, not to talk on. All voice traffic for linked groups happens on TS1:TG9.

Please don’t do this to “lurk” on a group.
Linked groups remain active for 30 minutes after the last local transmission, and only one linked group is available at a time.
Please do not transmit voice on any TGID not listed above.